Shine it up!

Let's talk about how I get your pieces to shine after they've been cleaned.

Reminder: You only need to clean your piece if they are truly dirty. For example, if they've been outside or if they haven't been dusted or polished in a while. Cleaning your piece is intended to remove dirt, dust, finger prints, and some of the previously applied finishes.

After a piece has been cleaned and thoroughly dried, it can be polished to a shine. An easy way to polish your piece is to use regular Pledge enhancing polish. It is important to note, you do not want to use the multi-surface cleaner in this case; just the polish.

This is what I do...

1. Lay your dry piece on top of a towel on a flat surface then spray lightly with Pledge.

2. Wipe down thoroughly with a soft cloth or extra soft paper towel. Be careful not to use anything abrasive when cleaning or polishing your piece. You do not want to scratch the glass or solder lines.

3. Make sure you remove all the excess that might build-up in the corners.

That's it!